Safari Rally inspired build, tall and off road capable 6G - GT |
Safari Rally inspired build, tall and off road capable 6G - GT |
Jul 23, 2018 - 12:26 PM |
|
Enthusiast Joined May 2, '18 From Phoenix, AZ Currently Offline Reputation: 0 (0%) |
I haven't ironed out all the plans, most project cars are open to constant change right. I will be converting this very cheap, high mileage car into another dual sport toy. If you dig around on the internet, you can find my other two Toyotas, 1984 Expedition Celica ( https://www.youtube.com/watch?v=PSNS9-qponY&t=16s ) and 1993 Lexus SC400 RX. This time around, pulling from my favorite sport of rallying, and favorite event, East African Safari Rally for all my inspiration, with maybe a little bit of Dakar thrown in. I purchased the car for $700, 278K miles on the clock but with a newer head installed not too long ago. With the help of this Forum, lots of research from various sources and encouragement from friends, the project is off to a good start. The red wheels, just not my style and 17" rims aren't going to cut it in the dirt...
Current work finished: -Maintenance on fuel and ignition system -debugged wiring to clean up the engine bay and get the cooling fans working properly -built custom SS header with race CAT and 2-1/2" dump pipe (to pass emissions) -tossed original struts and cut springs -installed 1997 Avalon struts and springs for travel and lift (rears are bolt on, front not really at all, used Rav4 tops, etc..) -2 of 4 custom engine mounts to replace broken OEM versions with Polyurethane -Jon |
Sep 18, 2020 - 10:34 AM |
|
Enthusiast Joined May 2, '18 From Phoenix, AZ Currently Offline Reputation: 0 (0%) |
I've done the research and the math and already started collecting what I think I'll need. Here's my plan as of now; 3S-GE BEAMS (Red or Grey Top), E250F tranny out of a '99 Rav4, get rid of the vacuum actuator for center diff lock replacing it with something simpler and smaller, mod'd prop shaft to the rear, possibly grafting Rav4 gas tank into the body, full custom rear subframe already built, RX300 rear diff, axles and drive hubs/brakes. Hear me out on this combo. Pull up the gearing on that gearbox, it's built for low to moderate torque figures and high RPMs, which should match nicely to the 3S-GE engine. I need reliability first, power second. If I have to change engines, might as well get a power upgrade over the 5S-FE. I love the possibilities of the 3S-GTE, but I can't trust a turbo engine not to overheat in the worse times. I live in the desert where I'm already battling heat just by going outside. I already picked up the donor Rav4, 1999 with a bad engine for $300. This gives me the time to pick all the pieces I want or think I might need without having to search salvage yards and pay a lot of extra money.
This post has been edited by Roodwerks: Sep 29, 2020 - 10:08 AM |
Lo-Fi Version | Time is now: November 22nd, 2024 - 10:19 PM |