updates on the Celica Options

[Phat_99CeliGT]

well, after 2 weeks of trying to get a tracking # from the seller, my Z3 sides finally arrived.

i put them on the Celica, and guess what?
THEY DON'T FIT FOR ****!!!

I have about given up on this damn car.
Im gonna track some people down and get some cash and have someone fit the kit.

Im still painting it, but im not gonna fit it.




I still have alot of work ahead of me.
i need to get someone to fit the front, fenders, sides, and rear bumper.
Im getting my new valves installed thurs morning.
im trying to find someone to do my seats.
Im getting help on my custom sub enclosure.
then im painting it myself

[NEVERSTOP]

Lookin good man! you dont have too much of a fitment issue.. I would take the tire well out though.. It will make that alot easier to do.. also you might wanna mess around with where your mounting holes are on the front of the fender.. you can do alot of moving around there.. also there are two little weldin in screws on the front corner.. make sure there sitting right.. I had mine off an it caused me a buncha problems, dont get frustrated man.. it takes time to get things right sometimes.. hell Ive been working on mine for 2 years plus now

edit: also on your invader front make sure you have that bottom section of your kit under the bottom of the lowwer support beam.. that can hang up there and cause problems.. you might need to remove all of your under cover pieces if you havent already done so.. also you have a FMIC correct? if so maybe try triming some of the section that comes into on the big center section where the IC is.. if its touching then it might make it so where the bottom of the front wont come back far enuf - hope you understood that - LOL

This post has been edited by NEVERSTOP: Apr 6, 2004 - 11:48 PM