6G Celicas Forums

Welcome Guest ( Log In | Register )

> Oil and temp gauges, install questions
post Apr 26, 2004 - 2:33 PM
+Quote Post
mikew04



Enthusiast
***
Joined Feb 19, '04
From austin tx
Currently Offline

Reputation: 1 (100%)




I have an oil pressure gauge, and a water tempurature gauge, both mechanical, and i was wondering exactly how you install them. For the oil pressure, from what i read and searched, i find the sending unit, and use a t-fitting off of it. Where exactly is this? ive read that it is near the exhaust manifold (5SFE) but im not sure exactly. Also, where do i run the water temp sensor to?
Thanks
-mike

Edit: another Q, with the oil pressure line, it says to slide the hex nut on the nylon tubing, then a ferrule, and then tighten the nut onto the engine fitting... it seems like the tubing would want to just slide out (especially if it is under pressure) will tightening down the nut keep the tubing secure to the fitting?

This post has been edited by mikew04: Apr 26, 2004 - 4:52 PM


--------------------
user posted image
 
Start new topic
Replies
post Apr 28, 2004 - 1:04 PM
+Quote Post
mikew04



Enthusiast
***
Joined Feb 19, '04
From austin tx
Currently Offline

Reputation: 1 (100%)




Anyone?


--------------------
user posted image

Posts in this topic


Reply to this topicStart new topic
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: December 4th, 2024 - 11:41 PM