intake question, about my intake setup Options

[HaRv3sTeR]

I bough an intake from 95celgt (legit seller...and good stuff btw)

In the kit...he gave me a tube to join the intake pipe (from a small exit halfway on the pipe) to the valve cover but when Ive installed the intake I tough that the tube was to connect the air temp sensor to the intake (isnt a bad idea, after all, I thinK...because the sensor fits really well in the tube and it looks to be stable there)

I already have a tube goin from the intake throttle body to the valve cover..and my question is....should I remove that tube and join the intake to the valve cover with the tube that 95celgt gave me and then drop the sensor in the filter ...or just leave it like that and ill be fine???

[Anub1s]

Okay, looking at my engine bay I see that the tube is just giving your valve cover some fresh air. It won't hurt it to run that tube to your new intake. Just make sure that you cap off the inlet at the throttle body if you choose to do so. It also is not going to hurt it if you keep it the way that it is. I'm sorry I couldn't give you a straight answer before but.....yeah... Hope that helps.