Nice JDM tails Options

[0Re0]

This post has been edited by 0Re0: Sep 1, 2004 - 7:24 AM

[playr158]

ok just take off the plastic that runs around the lights (the outside) the turn signal part just take out the yellow piece(easy there is already a post of 1 person who JUST did that)
for the two red circles, that is the stock location anyways so you get a piece of pipe which has an OD that is a hair smaller than the width of 1 red section and slide it in, paint with a chrome/silver(or black as the picture shows) paint. use red plastic circle piece to make red...the reverse light is stock clear...
then cut a clear plastic piece the same shape as the stock red outside piece and reattach....harder then it sounds put can be done in a day with imaginiation

This post has been edited by playr158: Sep 1, 2004 - 5:20 PM