jdm SIDEMIRROR wiring INFO, attention NEVERSTOP, CTCAT2049 Options

[playr158]

OK after about 10 min....3 15amp fuses and some playing

if you hook the RED wire at the MIRROR to a power source
then a GROUND to the BLACK wire at the MIRROR you get it to move DOWN
then a GROUND to the BROWN wire at the MIRROR you it to move RIGHT

thats as much info as i have now....
BUT that is not goin through the "relay/control switch" that is just wires to wires

[Batman722]

after doing some research I have a question for SliverGT

looking at the UK how 2 on http://www.yellowsun.plus.com/how2/retractmirror.html

The old and new wire colours for the control units are the same so you just join colour to colour
Control unit Power = GY
Chassis = W/BK
Common feed = LG/R
Right Vert. = LG/BK
Right Hori. = LG
Left Vert. = BR/Y
Left Hori. = BR/W
Retractor + = R/Y
Retractor - = BL/W

and looking at your USDM loom colors

The corresponding USDM loom colors

1 - retractor motor
2 - retractor motor
3 - spare
4 - left vertical adjuster - BR/Y
5 - chassis - W/BK
6 - power +12v - GY
7 - right horizontal adjuster - LGR
8 - right vertical adjuster - LGR/BK
9 - common feed to adjusters - LGR/R
10 - left horizontal adjuster - BR/W


2 wires don't match up - the RH and the common feed are switched. Just a mistake ? Are you sure the USDM / UK / JDM control unit wires all match up ? or are they different with the USDM (2 wires) ?

EDIT : also, the + and - from the mirrors just go directly to the + and - of the control unit ?

This post has been edited by Batman722: Nov 5, 2004 - 11:21 PM