Me just thinking at work again |
Me just thinking at work again |
Nov 29, 2004 - 3:19 AM |
|
Enthusiast Joined Nov 4, '02 From Hecho en la Republica Dominicana/Living in NJ Currently Offline Reputation: 0 (0%) |
Ok so as most of you know I do much of nothing at work..
know what do your guys thinking about a 5sfte with a stand alone? i was think that would be nothing but good .. you'll get to monitor the engine better and change what needs to be .. and squeez more power of it... i'll go more into detail later.. but i want to read your guys thoughts.. -------------------- |
Dec 3, 2004 - 2:55 PM |
|
Enthusiast Joined Aug 30, '02 From Maryland Currently Offline Reputation: 8 (100%) |
Jumped in on this thread on the 3rd page. Read a little bit of it but im sure its full of "Just 3sgte it"
If you go with standalone do a 5sGTE. With the standalone you can control the 3s head with no problems. Yes you can put a 3s in there but where would be the fun? stand alone CP pistons + Total seal rings 3sgte rods or your likeing 3sgte head (P&Ped) 5s block This would be a fine settup and the biggest flaw would be the trans. And if you look at it that way many of you swappers have the same trans. -------------------- Member of Team 5sfTe
|
Lo-Fi Version | Time is now: November 27th, 2024 - 7:21 PM |