GB: CF License Plate Holders, (Part the License Plate goes on) Options

[Consynx]

I'm going to make a sample picture later tonight, but here's one DoGGy made in the CF Hatch Thread.

These will cost roughly $200, and the method of how they will be made is still to be determined.
it will be about $200 if they are pure CF, but cheaper if they are fiberglass molds w/ CF overlay...

I will give a definate price later in time, but expect to pay about $200


This is just an interest thread
and I shall start the list:

1) ConSynX

[Digndoug]

i'm not goin to jack your thread

but i could get the plate in c/f
instead of stock
the "filled in" version
i think that would be a better thing
[right][snapback]236281[/snapback][/right]

You mean what i did.

Sorry i ment to add this with my first post, but im tarded

EDIT: Ok so after talking to TI, This is just a replacment? Thats not going to save wieght??

This post has been edited by Digndoug: Jan 24, 2005 - 1:28 PM

[doGGy]

Wrong.

No added weight for sure, cuz this will be made from FG and CF. It wount be made from stock plastic + fillint the area with another piece of plastic, adding bondo and etc..

And like My94RedCelica said - this will be made just for the guys from the CF hatch tread, to extend the CF theme.

i'm not goin to jack your thread

but i could get the plate in c/f
instead of stock
the "filled in" version
i think that would be a better thing
[right][snapback]236281[/snapback][/right]

You mean what i did.

Sorry i ment to add this with my first post, but im tarded

EDIT: Ok so after talking to TI, This is just a replacment? Thats not going to save wieght??
[right][snapback]237672[/snapback][/right]