RWD Celica, Swapping Supra drivetrain into Celica Options

[darksecret]

I know some might flame me for this but I was doing some research and the Supra is almost the same size as the Celica, wheelbase is only around 23mm apart and the width hopfully rotor to rotor (still need to get exact measurement) is only 98mm apart. the width wont be much of a problem due to the flare on the rear fenders and length can be overcome by a custom bellhousing that will be required. I got the idea from the Top Secret Supra. I know the Getrag will be a tight fit but it might be possible to do this without cutting the firewall. I'm know most of the parts I need and I know how RWD vehicles are set up so that is covered, I also have a live in welder (uncle) so fab work isn't an issue. Some might think this is highly impractical and they're right but it's a great concept that I will pursue. I'm going to hit up Supra forums and try to get more measurements for the drivetrain, etc. If anyone that can help with research it will be appreciated. Anything will help but I could use shifter placement, 3S-GTE width pully to output shaft and Getrag input shaft length. As I pursue this project I will post what I can and if it bombs at least there will be information for any other brave soul that wants to take this on.

[Digndoug]

I would like to see this too, but why not make a rear wheel drive with the 3s-gte, thats should cut back a lot of extra time work engery money fabbing.. just a thought?

I think a rwd celi is a rwd celi.. An the 3s-gte would make a lil more sence.
[right][snapback]257288[/snapback][/right]

How do you propose getting the rear wheels to spin from a horizontally mounted motor?
[right][snapback]257301[/snapback][/right]

haha, yes i guess i over looked that.. thinking more use the awd tranny. but NM

I think if you want a rwd car, get one thats stock.