Another 3s swap problem, driver's side axle pops out Options

[celica3sgte]

For reference, I have a 2nd gen 3sgte with 92 mr2 lsd tranny. I'm using st185/mr2 hybrid axles. I finally put my rear motor mount in yesterday and the motor is sitting very solid now. The problem is, now my driver's side axle keeps popping out, and I lose all the tranny fluid. I know a couple of you had problems with these axles breaking cv joints on this setup. I definetly think that this axle setup is too short now. I always noticed that the outer cv joint is very stretched on both sides. I was doing some research and found out that the mr2 wheel base is 94.5 inches and the 94 celica wheelbase is 99.9 inches. I think this is the problem. Before it wasn't a problem b/c the motor was shaking with the axles and it wouldn't pop out, now with it being solid, the axle can easily shift out of the tranny. Any of your thoughts are welcome.

And one more thing. Does anyone know how long an st205 axle is. The compressed and extended lengths?

This post has been edited by celica3sgte: Aug 17, 2005 - 4:48 PM

[Rjb23]

Ok I looked it up and the 92-96 camry wheel base is 103", solara 105", Where ours are 99.9", where the mr2 is 94.5.

Now will the 92-96 camry axles seperate into to peices and bolt up to the mr2 turbo axles? And if they do what will the length of them be?

Also how different are the st185 axles from the mr2 axles?

This post has been edited by Rjb23: Aug 20, 2005 - 12:41 AM