VVT-i?? Cams upgrade, VVT-i + Cams |
VVT-i?? Cams upgrade, VVT-i + Cams |
May 16, 2003 - 9:14 PM |
|
Enthusiast Joined Oct 27, '02 From Barbados Currently Offline Reputation: 0 (0%) |
Hi all!
I think that I have mess up. My Mechanic have a Gen 1 4AGE 20v Silver top with upgraded 264 cams with VVT He stated to me that he still have vvt. VVT is in this case is either on or off. VVT-i is variable VVT. Now if what he stated to me is true(which I do not have any doubt), that means that you may not lose vvt-i if you have upgrade your cams Maikl! His cams was purchase for the 20v. I do not know if there are from Todaracing or TRD, by there cam from Miami. I will try and see how the VVT setup works in this case tomorrow. Just did some research, and it may seem right now that toda offer cams for VVT system. In fact, with further research, VVT and VVT-i is in the VVT controller. But here is where the problem can arise. Qoute from Bill Sherwood (http://www.billzilla.org/vvtvtec.htm):- "The early VVT system was relatively simple, ie, at a specific rpm (~4400rpm on the 20 valve 4AGE's) the computer signals the OCV to open, this lets oil pressure go through a special gallery in the #1 inlet cam bearing, through the centre of the inlet cam to the VVT pulley. There's a small piston in the VVT pulley, and once it gets enough pressure behind it, it starts to move outwards, causing the outer part of the pulley to turn in relation to the inner part, due to the helical spline that guides the piston's fore & aft movement." So if you purchase a cam not design for vvt, good bye vvt, but if you buy a cam enable vvt, you are in luck So Maikl, there may be some hope for you. Looking at todaracing, you can get cams with vvt. My mistake was that once you go to a big cam, you would want to dial in the HP and torque for you driving habits or where there just occurs at their max. If you use a Cam Gear, you will lose vvt, vvt-i. So maikl, http://www.todaracing.com/products/toyota/..._3sg_specs.html 264 would be good for you. Idle a little rough This post has been edited by west_minist: May 18, 2003 - 9:00 PM |
May 19, 2003 - 9:13 AM |
|
Enthusiast Joined Mar 3, '03 From cyprus Currently Offline Reputation: 0 (0%) |
thanks again you realy take this seriusly but i am a bit of confused i dont know what cams to get please tell me wich ones to take
-------------------- |
Lo-Fi Version | Time is now: November 28th, 2024 - 9:46 PM |