Cracked oil filter relocation kit, how does this happen? Options

[CheesyLobster]

I have an oil filter relocation kit because my manifold would otherwise hit the oil filter. The other day, after driving for about 20 minutes on the freeway i see a huge amount of smoke coming from my car. i find that the oil filter kit has cracked where the lower tube pluged into the block. The kit was only a month old. What could have caused this? I don't want it to happen again with my next kit.

The oil lines ran really close too, if not touched the turbo manifold; do you think that could have overheated the oil and built up too much pressure? My oil pressure gauge didn't seem to indicate too much pressure. I assume that the oil would get just as hot at the exhaust anyways, right?

Or, do you think it was defective? Could it have been over tightened? It's strange because i had used the car for a week before and didn't have any problems.

Your input please?? Thanks.

[presure2]

those cheap relocation adapters are made of cheap cast metal.
they crack pretty easily.
you prolly overtightened the fitting, and the stress of vibrations and heat cycles caused it to crack.
if you want a relocation adapter that WILL NOT crack, try www.cantonracing.com
they have CNC'd adapters.
VERY robust.

[nik]

those cheap relocation adapters are made of cheap cast metal.
they crack pretty easily.
you prolly overtightened the fitting, and the stress of vibrations and heat cycles caused it to crack.
if you want a relocation adapter that WILL NOT crack, try www.cantonracing.com
they have CNC'd adapters.
VERY robust. 
[right][snapback]348931[/snapback][/right]

he's right cnc pieces are the only way to go for duriablity

This post has been edited by nik: Oct 25, 2005 - 5:41 PM