V-6 Camry axle and alltrac axles are different |
V-6 Camry axle and alltrac axles are different |
Oct 23, 2005 - 8:37 PM |
|
Enthusiast Joined Nov 12, '02 From Columbus, Ohio Currently Offline Reputation: 15 (100%) |
We all thought that they are identical. As a matter of fact, the hub end has the same number of splines. BUT, it is not the same size. So the camry axle will not fit in our 6gen hubs. So after I learned this I figured I would take the inner cv joint apart and put it on my broken st185 axle. The inner pieces on this end are different sizes as well. The shaft is different. And the grooves of the bearing are different. Here's a pic. Guys this really sucks, less availability.
st185 on left,,camry on right st185 spline hole is bigger. The small spaces between the ball bearing grooves are wider on the st185. steve |
Oct 27, 2005 - 1:47 PM |
|
Enthusiast Joined May 1, '03 From Michigan Currently Offline Reputation: 0 (0%) |
The Camry outer axle is thicker and almost 2" longer then the alltrac outer. You could swap the camrys outer CV joint with one from the alltrac, which would give you a longer version of the all-trac axle. I considered doing this, but it just looked too long.
Scott 90 All-Trac + Michigan This post has been edited by scothaniel: Oct 27, 2005 - 1:47 PM -------------------- Scott
West Michigan |
Lo-Fi Version | Time is now: December 4th, 2024 - 2:22 PM |