 Replacing outer shaft below |
 Oct 31, 2005 - 4:57 PM
|
 
|
 Enthusiast  Joined May 24, '05 From Malta Currently Offline Reputation: 0 (0%)  |
Hi guys. I need your help. Well last week i have noticed that my right hand outer drive shaft bellow was thorn and grease was split all over the suspension. I have ordered a set from Toyota and they arrived today.
This evening I tried to pull out the shaft to replace the below. But how do you do this. I removed the centre nut, the caliper and the disc brake. I tried pulling the hub out of the shaft with a bearing three arm pully but it seems too tight. Can you help me? Also I need to replace the gearbox fluid. What oil specs do I go for? Thanks for everything as always! |
 |
Replies
|
Oct 31, 2005 - 8:20 PM
|
|
 Enthusiast Joined Dec 27, '03 From Nor Cal Currently Offline Reputation: 0 (0%) |
Are you pulling on the hub? Typically when you replace a blown boot... you'll be pulling the axle out. To pull the axle out... you'll need to remove the tie rod and unbolt the spindle from either the strut or the lower suspension arm (wishbone)... After that, tap the axle and it should break loose from the hub... then tap it out of the tranny.
-------------------- "It's ok to be naked girl... I'm an artist!"
1995 AT200 Celica ST: stocked out daily driver... 1984 AE86 Corolla GT-SR5: silvertop 20V 4AGE project car jacked up with goodies... 1991 SW2x MR2 n/a: bare bones hardtop model soon to be... |
Posts in this topic
yozef Replacing outer shaft below Oct 31, 2005 - 4:57 PM
yozef by tie-rod do you mean the steering linckage Nov 2, 2005 - 8:24 AM
soulshadow If your replacing the drive axel you don't nee... Nov 2, 2005 - 9:30 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: March 2nd, 2025 - 10:34 AM |