Putting on Bullet Fenders, finally done w/ a few bad pics. Options

[JFrost9]

Ok, well im removing my fenders, and im stuck on a couple of bolts. I got all of them out except for the few that connect the fender to the bumper, and then the ones under the low beam.... How am i suppose to get to these? They are blocked by all the stuff for the headlights and then some other stuff...

do i have to remove the bumper to remove the fenders?


Thanks, Josh.

This post has been edited by JFrost9: Jan 26, 2006 - 7:34 PM

[JFrost9]

well after getting the fenders off i attempted to put the new fenders on... they came predrilled for the most part, but there are a few spots (like the connection to the bumper and at the bottom by the door). Ive read for the side skirts a normal drill bit would work, and i was just curious if the same thing applied to the fenders...