after swap, not turning over ?!!?!?!, advise Options

[Batman722]

here is the situation...a 94 5s went into a 96. The 96 harness was used and everything matched up except a few things (they were then swapped over from the 96 motor to the 94, i.e. distributer, OBDII, ect. ). Now after everything is all hooked up and put together, it doesn't start up. It cranks, the starter is good, but no vroom.

anything that I should check for specifically ?

any ideas ?

wtf ?

thanks

[lagos]

ok guys, ill step forward, its my car.

alright...

I used the exaust from the other engine...
I changed over the distributor
I changed over the wire harness
I swapped over a crank sensor
I swapped the egr

Now, I am getting spark, the fuel pump is working, the fuses are fine, and there is fuel getting to the fuel filter. I tryed using some starter fluid, i got it to studder a little but didnt run. I am now going to take a look at the hoses and the fuel rail to see if there is maybe a blockage. This is the last thing i can think of. is there a way to see if the injectors are firing?

if you got it to fire up with the starter fluid, then your problem must be fuel related, since you verified that the car and fire on its own.