cold air box, injen intake Options

[claudio]

Ok, let's say I get a injen intake with the heat shield. Is there a place where I can get a cold air box (already made) to fit in my 99' GT and be big enough to enclose that huge filter?

Or let's say I was going to build one out of aluminum where do I bolt it down to?

Has anyone built one? Any close up photos and/or instructions?

[CelicaSX]

Try keeping the stock box and getting a high flow filter. Once you have this run a 2.5 or 3 inch cold air intake pipe from under the car up to the factory air box.
(There are some air vents under the car on the plastic splash guard you can run the pipe thru.)

Then modify or cut & attach the cold air pipe to the bottom half of the stock/factory box. Seal all gaps.
You will notice the air intake that runs from the factory box into the side guard. This unfortunatly only sucks air from inside the guard.

The idea is you are getting cold (some what) forced air into the box & thru the filter.
A tip is to also put a stocking over the opening on the pipe under car to stop leaves and cigarette butts from getting in.

I had posted an instruction on the How-To page explaining it but they havn't posted it yet...
Maybe email Coomer & ask if they are going to publish it online..they might be testing it out first before they put it online.