Gen3 3SGTE Dyno Run, Guess my numbers! Options

[CilverSeliST205]

On either the 20th or 27th I am going to do a couple of pulls on a dynojet, so I would like for you guys to guess the results... so:

Altitude: 176meters above the sea level, predicted temp. ~ 65-75F

POWER MODS:
'95 Gen III 3S-GTE swap
99' Solara v6 tranny
Precision turbo FMIC (don't know the dimensions but i know its bar&plate)
2.5" mandrel bent IC piping
Apex'i intake
3" catless downpipe (xs power.... ewww....)
3" catless custom mandrel bent exhaust (or DG exhaust)
Magnaflow muffler
Blitz DSBC

I am going to do 2 pulls, one on stock boost ~14 psi and one at 17 psi, so guess for each pull.

I do not have the boost controller and muffler yet, so if anyone wants to advise against, or recommend something better than blitz dsbc or magnaflow muffler, please do so quickly before I order them...
Ill post the graphs and runfiles right after the dyno session

[CilverSeliST205]

Brian - Im not sure what is the hp rating for this intercooler, but when my intake air temp sensor and gauge comes in ill post the efficiency (little experimenting with co2, water spray, heat shielding, and ducted air box for the filter)

Lagos - I wouldn't go to a dyno that doesn't offer WB logging and i will bring floppies with me for the runfiles. 260-280 thats what im hoping for too

Def - How much extra $ would they charge me for boost log ? approx.? they are charging me 75$ for 2 runs with WB, im not sure if boost logging is included...

BBoy - Solara inners, not sure of the outers, custom spacers welded to get the lenght right... I'm a drivetrain noob and that is all i know about the my axles