MSD 2 bar map sensor., leaner a/f's? Options

[penguininatux]

Alright, i talked to a few people about this subject of using an msd 2 bar map sensor. My problem was that i was just gettin wayy rich readings at idle and during acceleration ( too rich to even drive), with my new 460cc's being controlled by an SAFC II. Anyways, i heard from a few people that using a 2 bar would help lean out my a/f's throughout idle and all rpms. So i installed it today. Seems like nothing has changed. I tried wirinig it in differently with no change again.

First off does anyone know the wiring of of a stock 5sfe map sensor, and then one for the 2 bar MSD pt#2312?

( just so i know i wired it in correctly)

And secondly. Why arent my a/f's dropping after installing the 2 bar? should they be?

feeback is greatly appreciated (seriously)

Thanks

Dan.

Innovate wideband btw.

Oh and for Manny (pressure2) if you're lookin at this. or someone else with a similar to setup as us, if you could remove the 2 bar while idling (just the plug) and see if you're a/fs get really rich. that would help to determine if the 2 bar map actually makes a difference in A/F's

Thanks again to anyone who has the time to help!

[NateG]

What sensor number are you useing on your safc for the input and output. Since you changed to the 2 bar.