6G Celicas Forums

Welcome Guest ( Log In | Register )

> Interior Door Fabric
post Jun 16, 2006 - 12:33 PM
+Quote Post
JonMarkos



Enthusiast
**
Joined Jun 13, '06
From Omaha, Nebraska
Currently Offline

Reputation: 11 (100%)




The fabric on my door panels is coming off (the glue isn't holding anymore), I took it to an upholstery shop and the guy said that it would be impossible to reglue the fabric back on since it is hard to find a glue that holds to vinyl, but the car came like that from the factory and the fabric held for almost 9 years, does anyone know of a glue I can use, or a way I can set the fabric so that it holds? The door looks fine without it but I think the tan fabric really adds to the cars interior...
IPB Image

It is the fabric pictured on the passenger door here, the drivers side door fabric is completely removed...


--------------------
IPB Image

We shall show mercy, but we shall not ask for it.
 
Start new topic
Replies
post Jun 16, 2006 - 1:03 PM
+Quote Post
playr158



Enthusiast
*****
Joined May 22, '03
From NOVA
Currently Offline

Reputation: 16 (100%)




pull off wat you have
take a drill with a very thin bit and drill in a couple holes to give the glue something to sink into and bite down on...then apply your new cloth..should probably hold a little better

3m spray glue might be good for this project as well
post Jun 16, 2006 - 4:55 PM
+Quote Post
JonMarkos



Enthusiast
**
Joined Jun 13, '06
From Omaha, Nebraska
Currently Offline

Reputation: 11 (100%)




QUOTE(playr158 @ Jun 16, 2006 - 1:03 PM) [snapback]445375[/snapback]

pull off wat you have
take a drill with a very thin bit and drill in a couple holes to give the glue something to sink into and bite down on...then apply your new cloth..should probably hold a little better

3m spray glue might be good for this project as well



Drill holes into where, the outer edge around the vinyl piece that the glue covers, or on the inside surface? I think the biggest concern the guy at the upholstery shop had was the outer edges where the vinyl pieces met...are you saying I should drill all the way around that center piece?


--------------------
IPB Image

We shall show mercy, but we shall not ask for it.

Posts in this topic


Reply to this topicStart new topic
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: February 24th, 2025 - 8:24 AM