How to make AC work with your swap, aka: Need help with AC wiring thread Options

[lagos]

ok... so my AC hasnt worked since the swap and i figure now is a good time to wire that crap up. so i have my harness apart and im trying to look at the wiring diagrams to figure out a few things. seems like i need some help.

"ac amplifier" in the diagrams means the main AC compressor, correct?

on it, is a plug called A8 (looking at the 5sfe diagrams). the harness goes from there to a plug called IM1 and then 3 wires go to the ECU's 1st plug. where is IM1 located ? is it the white, 5 wire plug that goes from the 3s hanress, and plugs in right behind the glove box?

This post has been edited by lagos: Jul 29, 2006 - 9:02 PM

[lagos]

ah ha! nice find.

i was looking at the AC specific diagrams and wondering why it wasnt there.

so it seams like there is a problem with adding AC idle up. on the 3sgte the idle up control is done by the AC amp.

in the 6th gen the AC amp dosnt have this function, because it is handled by the ECU.

so it seems there is no way to do it the way it is from the factory.

since the Idle up, only gets triggered when the AC clutch engages, i was thinking that maybe i can get it to work by splicing into the blac/white wire that supplies power to engage the cltuch on the AC compressor. this way, every time the clutch would come on (and make the rpm's dip down) the AC idle up would get 12v, and open its vac ports and make the car idle up. what do you guys think?