Rear Motor Mount question...., how do i get it back on?!? Options

[Silver94CelicaOw...]

I've been working the past few days on changing my clutch and finally got most everything put back together today, only one problem - How in the hell do I get the rear engine mount back on the crossmember and put it back in??

I unbolted the two nuts and one bolt from the crossmember holding down the mount, and somehow the mount poped of when I was removing the trans. The BGB says to remove the bracket from the block, but that doesn't make any sense because if you were to take off the bracket and then reinstall the mount that way, you wouldn't be able to get to the bolts to put the bracket back on! It makes no sense to me....I've been wrestling with the damn thing for a good part of the night and its now 5:45 AM and I haven't slept yet because I feel like an idiot for not being able to figure it out. lol


Any suggestions?? I'm all out of ideas and I gotta get my car back on the road this morning.

[Elevindie]

I replaced my clutch on my st this winter, and it was also really hard to get the rear tranny mount back in. BUT it will work. I used some leverage to slip it in.