Bolt Stripped on Crank, Need Help Options

[Justin]

I was changing my timing belt today (7AFE) when it happened. The puller I was using (Autozone loaner, go figure) went sideways when I was removing the crank pully. It trashed the threads on the crank and now the bolt won't go back in. The bolt is now also trashed on the threads though. It would feel good going in but would stop and this is what I ended up with. Also, when I removed the bolt I didn't have to even use a socket it just turned right out by hand.

So now I can only come up with one solution. I would have to re-tap the crank. But in order to do that I'm pretty sure I will have to get that wierd washer off of the stock bolt by I guess cutting it. Then, drill it out to the bigger bolt size that I tapped the crank to. Any suggestions or ideas on fixing this?

[Justin]

Unfortunately the crank threads did get stripped as a result of that wonderful loan a tool but I will try that. Too bad I gotta wait till Monday to go to toyota. I need to go to work but not now. Is that something you think toyota will have?