3sgte 3rd gen swap problems solved weeeeeee, Finally started Options

[urbandork]

the engine is droped in and i had everything wired up but it wont start or even turn the engine over....

im using the 3 gen 3s wiring harness and connecting it to the connections that are in my 95 5s fuse box.
ihave noticed that there are a few wires that dont plug into anything on that main plug, the one with that platic hold down that pivots to secure the plug in.
the wires on the harness sid that dont connect with anythin on th car/5s side are a green with red and a single silver strip, a solid blue with one silver strip, and a slightly thicker blue with white and a single silver line.

what do these three connect to?

ive also noticed that on the in side if the car that there ar three plugs that are in front of the ecu,betwen the ecu and the shifter assembly, these three plugs are stacked vertically. while the plugs fit some of the wires dont connect to any thing.


sdsfgdvdjfsfjf@!$#!%~!!!!!!!

im going to cry soon ahhhh


what wires do what and which ones do i have to worry about????

This post has been edited by urbandork: Oct 30, 2006 - 4:08 AM

[lagos]

you need to wire in the COR and fuel pump relay, from what i hear. its not all just plug and play.

[urbandork]

you need to wire in the COR and fuel pump relay, from what i hear. its not all just plug and play.

whats the COR stand for?

and how would i wire them up????

also im still trying to figure out what those three wires do. I traced them back to the ecu and found the pins the the sticky of the wiring diagram is either for a 2nd gen and slightly diff on the 3rd or im messing something up.

the wires again are

green with red line and a silver strip.. i looked at the clip and it looks like its just a simple power line. the car has that color wire on a few things such as the horn so perhaps it needs power so it can open ur a relay?

solid blue with silver strip... leads into the ecu but not sure what it does

blue with white line and sliver stirp... also leads inso the ecu. i tried following the two wires back, the oposite way of the ecu, and found that they just ended and had tabs thingies on the end. it looks like they were hooked up to something but when i got the clip it had been disconnected.

thanks for all the help u guys im really in a bad spot .... im good with the wrench but with electronix im blah.