3sgte 3rd gen swap problems solved weeeeeee, Finally started Options

[urbandork]

the engine is droped in and i had everything wired up but it wont start or even turn the engine over....

im using the 3 gen 3s wiring harness and connecting it to the connections that are in my 95 5s fuse box.
ihave noticed that there are a few wires that dont plug into anything on that main plug, the one with that platic hold down that pivots to secure the plug in.
the wires on the harness sid that dont connect with anythin on th car/5s side are a green with red and a single silver strip, a solid blue with one silver strip, and a slightly thicker blue with white and a single silver line.

what do these three connect to?

ive also noticed that on the in side if the car that there ar three plugs that are in front of the ecu,betwen the ecu and the shifter assembly, these three plugs are stacked vertically. while the plugs fit some of the wires dont connect to any thing.


sdsfgdvdjfsfjf@!$#!%~!!!!!!!

im going to cry soon ahhhh


what wires do what and which ones do i have to worry about????

This post has been edited by urbandork: Oct 30, 2006 - 4:08 AM

[4g-gt-four]

so when you turn the key to the position that the car would normally run in the starter stays on? The other relay box that sits up near the rad holds the intercooler pump relay, fuel pump relay and dimmer relay. Also the fuses for the left and right high beams. What is the current problem? Because there is nothing in this box that should give you trouble with the starter circuit.