My audio project (56k slow), click on thumbnails for larger pics Options

[soven]

Not many people seem to be too into audio here. Just going to put up my current work in progress. This is a SQ setup. 3 way active front + sub. Headunit connected optically to h701 processor. All inputs welcome

Gear:
Alpine 7998r fantomface headunit
Alpine F545 amps (2 of them)
Alpine CHA-S624 changer
Alpine H701 processor + Rux controller

Drivers:
Seas L18-RNXP 7" midbass
Hybrid Audio Legatia 3" mids
tweeters unconfirmed(DLS UP1C or seas neo)
Phase Linear Aliante 12" sub

TODO list:
- Cut kickpanel for install of 3" mids.(better pathlength difference and more footroom(no change from stock)
- Fiberglass kicks etc.
- Boot install
- Reinstall midbass drivers
- A pillar tweets

Aliante and legatias


Headunit installed in stealth manner:



This video I found, shows how it works:
http://www.youtube.com/watch?v=sDau1aWIvoo...ted&search=

Cable routing :
Convenient grommet next to battery in engine bay


Inside wheelwell:


Managed to fit the power cable through grommet.


Ran 3 sets of speaker wires. Midbass,mids,tweets. Making sure I have enough slack in the cables to not require a rerun.



Done:


Will cut my kickpanels. The bit of metal to the right of the speaker wires hanging down. 1mm -ish thick. will allow me to sink the 3inch midrange speaker deeper into kickpanels and also allow more footroom and minimise pathlength difference.



Trunk - About to embark on install -




still deciding if I should make my life hard and have side mounted amps or just go with false floor amp setup.

This post has been edited by soven: Nov 27, 2006 - 3:18 AM

[vsideboy]

Should be good when its finished mate.
Go for the extra work side amps, you'll only end up regreting not doing it in the end.

I keep meaning to get around to doing something with mine, had a couple of subs sitting in my house for 3 years now, just not had time.