6-speed trannys???, anyone droppin 6-speed trannys into their car, or have... Options

[mneal2_92788]

has anyone dropped a 6-speed into their celica or if not can you??? if so on either, how much does it cost and where do i find it???

[3WayStunna]

yah, i love to revitalize dead topics, but anywho, isnt the beams altezza engine 6spd......couldnt u use the tranny from that with another 3s series engine??....with the right fabrication i believe it can be done...true i have nothing to back that up, but after reading of ppl doing v6 swaps, supercharged 3sfe
s and many other things, it could be possible right?? or am i jsut talking nonsense??

[InfamousChappy]

I think it's all nonsense.Isn't 5 gears enough shifting already? That and the fact you would probably never use the 6th gear.

Celicas werent engineered with 6 gears in mind. Like most sport compacts, 5spd is the staple.
6 spd trannys are suited more for high power 6,8,10,12 super cars. Where 6 gears is necessary.

Ok so it could be done..But..Why?

[Fastbird]

I think it's all nonsense.Isn't 5 gears enough shifting already? That and the fact you would probably never use the 6th gear.

Celicas werent engineered with 6 gears in mind. Like most sport compacts, 5spd is the staple.
6 spd trannys are suited more for high power 6,8,10,12 super cars. Where 6 gears is necessary.

Ok so it could be done..But..Why?

That makes no sense at all. Look at the S2000, Civic, RSX, 7th Gen Celica, new MR2 (SMT6 tranny), and a handfull of others. All with six speed transmissions (or at least available). It's not a matter of how many times you shift, it's a matter of gearing. With a stock motor (5S or 7A), sure, the Celica needs the steep gearing and final drive ratio as stock to keep it from being too much of a burden to get moving in traffic without impeding others. But, for some of us who do a lot of highway cruising or have upgraded to a 3S-GTE, we don't need that steep gearing. And personally, I HATE driving the celica on the highway for extended periods of time because at 80 MPH, turning 4K rpm's with the custom exhaust droning away is flat out tiring. It would be MUCH nicer to have the same 1-5 gears (or close) with a more overdriven 6th gear for those highway cruising period.

Six speed transmissions aren't just reserved for high power "super cars" like you think. The main reason the six speed came into prominence is the extra overdrive gear for improved fuel economy, be it on a 4, 6, 8, 10, or 12 cylinder engine.

[Kwanza26]

That makes no sense at all. Look at the S2000, Civic, RSX, 7th Gen Celica, new MR2 (SMT6 tranny), and a handfull of others. All with six speed transmissions (or at least available). It's not a matter of how many times you shift, it's a matter of gearing. With a stock motor (5S or 7A), sure, the Celica needs the steep gearing and final drive ratio as stock to keep it from being too much of a burden to get moving in traffic without impeding others. But, for some of us who do a lot of highway cruising or have upgraded to a 3S-GTE, we don't need that steep gearing. And personally, I HATE driving the celica on the highway for extended periods of time because at 80 MPH, turning 4K rpm's with the custom exhaust droning away is flat out tiring. It would be MUCH nicer to have the same 1-5 gears (or close) with a more overdriven 6th gear for those highway cruising period.

Six speed transmissions aren't just reserved for high power "super cars" like you think. The main reason the six speed came into prominence is the extra overdrive gear for improved fuel economy, be it on a 4, 6, 8, 10, or 12 cylinder engine.

*sigh*

Lemme explain a few things. A LOT of new cars are now coming with 6 speeds and 7 speeds... why? Sporty feel and fuel economy. The issue? Well... those trannies were DESIGNED for those engines... therefore the gearing is perfect (or damn near perfect). This topic talks about 'bolting' up a 6 speed... without any understanding of gearing and how it affects performance. Let me give you a good example of BAD BAD gearing. 7th gen Celica GTS. Potentially a 15 FLAT stock car... yet when mated to an older POORLY geared tranny (stock auto)... the car turns into a 17 second slug. 15 seconds versus 17 seconds is like... 5-7 car lengths. While potentially having a 6th gear can be done correctly... can anyone afford a custom gearset? Who wants to pay up for a custom tranny that's gonna cost almost as much as the car itself?

[Fastbird]

That makes no sense at all. Look at the S2000, Civic, RSX, 7th Gen Celica, new MR2 (SMT6 tranny), and a handfull of others. All with six speed transmissions (or at least available). It's not a matter of how many times you shift, it's a matter of gearing. With a stock motor (5S or 7A), sure, the Celica needs the steep gearing and final drive ratio as stock to keep it from being too much of a burden to get moving in traffic without impeding others. But, for some of us who do a lot of highway cruising or have upgraded to a 3S-GTE, we don't need that steep gearing. And personally, I HATE driving the celica on the highway for extended periods of time because at 80 MPH, turning 4K rpm's with the custom exhaust droning away is flat out tiring. It would be MUCH nicer to have the same 1-5 gears (or close) with a more overdriven 6th gear for those highway cruising period.

Six speed transmissions aren't just reserved for high power "super cars" like you think. The main reason the six speed came into prominence is the extra overdrive gear for improved fuel economy, be it on a 4, 6, 8, 10, or 12 cylinder engine.

*sigh*

Lemme explain a few things. A LOT of new cars are now coming with 6 speeds and 7 speeds... why? Sporty feel and fuel economy. The issue? Well... those trannies were DESIGNED for those engines... therefore the gearing is perfect (or damn near perfect). This topic talks about 'bolting' up a 6 speed... without any understanding of gearing and how it affects performance. Let me give you a good example of BAD BAD gearing. 7th gen Celica GTS. Potentially a 15 FLAT stock car... yet when mated to an older POORLY geared tranny (stock auto)... the car turns into a 17 second slug. 15 seconds versus 17 seconds is like... 5-7 car lengths. While potentially having a 6th gear can be done correctly... can anyone afford a custom gearset? Who wants to pay up for a custom tranny that's gonna cost almost as much as the car itself?

You don't have to explain anything to me. I fully realize what I said. What you missed was the fact that my rant was based on the fact that I'm running a 3S-GTE and have no need or desire to turn 4K RPM's on the highway and certainly don't need such steep gearing to get the car moving in a timely fashion now. Your statement is flawed also, and I'm going to step out of the Celica world and into the GM world for a second to say why: Take the 4th Gen 93-02 F-Body and the 92-96 LT1 C4 and 98+ C5 and C6 Corvette's. I own Two 93 F-Body's and a 99 C5 Vette so I speak from personal experience as well as loads of practical experience. Those cars mentioned, save for the 92-96 Vette (ZF6 6 Speed) run Borg Warner T-56 6 Speeds. The F-body's got 3.23 or 2.73 rear end gears in 93 and 3.42 rear end gears in 94-02 and the Vette's got 3.42 rear end gears in 97 to current. This is NOT optimal gearing for the car, this was specifically a way for gm to overdrive the car more and cut down on the gas guzzler taxes while at the same time providing a stronger transmission than what was previously available. If you've never ridden in any of the above stock and then with a set of 3.73, 3.90, or 4.10 gears out back, then you don't realize how low geared they really are from the factory. Stepping back into the celica/import world now.

I fully realize that a certain amount of engineering goes into why cars get six speeds, and will admit that the import world is more engineered because is HAS to be given the inability of some of the cars to get moving quickly enough. Not a bash, just a reality. Close gears and steep gearing/final drive ratio is an absolute necessity. But another flaw in your example above is when you used the example of an auto tranny. Too bad we're not talking auto's. I bet if you compared the gearing of the six speeds (i believe there was just a thread on here talking about a rare six speed from a Curren or something) you'd find that the gear ratio's are probably quite close and wouldn't harm acceleration as much as you'd think while still providing a more reasonable cruise gear. Given the Celica's relatively high final drive ratio with the 5 speed, moving to a six speed probably wouldn't have much of an impact at all. Sadly though, without some major engineering or a stroke of genius somewhere, we probably won't find out.

My point in making my orignal post was simply that for the motor swap guys, you could potentially increase fuel economy and reduce the engine speed at highway cruise without hurting acceleration (possibly increasing it because of a less steep 1st and 2nd gear allowing better power transfer to the ground via less torque multiplication from the lower gearing) and givng the car some longer legs for the top end (should the need arise) at the same time.

[Kwanza26]

You don't have to explain anything to me. I fully realize what I said. What you missed was the fact that my rant was based on the fact that I'm running a 3S-GTE and have no need or desire to turn 4K RPM's on the highway and certainly don't need such steep gearing to get the car moving in a timely fashion now. Your statement is flawed also, and I'm going to step out of the Celica world and into the GM world for a second to say why: Take the 4th Gen 93-02 F-Body and the 92-96 LT1 C4 and 98+ C5 and C6 Corvette's. I own Two 93 F-Body's and a 99 C5 Vette so I speak from personal experience as well as loads of practical experience. Those cars mentioned, save for the 92-96 Vette (ZF6 6 Speed) run Borg Warner T-56 6 Speeds. The F-body's got 3.23 or 2.73 rear end gears in 93 and 3.42 rear end gears in 94-02 and the Vette's got 3.42 rear end gears in 97 to current. This is NOT optimal gearing for the car, this was specifically a way for gm to overdrive the car more and cut down on the gas guzzler taxes while at the same time providing a stronger transmission than what was previously available. If you've never ridden in any of the above stock and then with a set of 3.73, 3.90, or 4.10 gears out back, then you don't realize how low geared they really are from the factory. Stepping back into the celica/import world now.

While that may be the case with Corvette and other big V8's... there's a flaw in your argument. You CANNOT compare muscle cars to imports... why? Muscle cars can run fine with taller gears... in many cases much faster with taller gears when compared to imports. TORQUE. Back to my example... the difference between a well matched 5 speed and a poorly matched 6 speed can be HUGE. GM understands that many Corvette buyers aren't gonna buy a corvette specifically to race... so the need for shorter sporty gearing that can hurt fuel economy isn't neccesary, so they have the taller finaldrives to attract the not so performance oriented buyers.

I fully realize that a certain amount of engineering goes into why cars get six speeds, and will admit that the import world is more engineered because is HAS to be given the inability of some of the cars to get moving quickly enough. Not a bash, just a reality. Close gears and steep gearing/final drive ratio is an absolute necessity. But another flaw in your example above is when you used the example of an auto tranny. Too bad we're not talking auto's.

Why is it flawed? We're talking about gearing... not whether a driver or tranny can perform shifts better. You're from the domestic world right? Which is preffered in a drag race?

I bet if you compared the gearing of the six speeds (i believe there was just a thread on here talking about a rare six speed from a Curren or something) you'd find that the gear ratio's are probably quite close and wouldn't harm acceleration as much as you'd think while still providing a more reasonable cruise gear. Given the Celica's relatively high final drive ratio with the 5 speed, moving to a six speed probably wouldn't have much of an impact at all. Sadly though, without some major engineering or a stroke of genius somewhere, we probably won't find out.

Unfortunately as myself and many others have pointed out OVER and OVER... there is ONLY one toyota 6 speed transaxle... mated to engines that both peak power near 8000 rpms. Besides... how often has someone come in here asking about 6 gears with even a remote idea of what gearing is?

My point in making my orignal post was simply that for the motor swap guys, you could potentially increase fuel economy and reduce the engine speed at highway cruise without hurting acceleration (possibly increasing it because of a less steep 1st and 2nd gear allowing better power transfer to the ground via less torque multiplication from the lower gearing) and givng the car some longer legs for the top end (should the need arise) at the same time.

This last part sounds like something muscle car guys would say. Just remember... we're talking 4 cylinders here... but as I've mentioned already... there are 5 speed trannies available that mate up to the 3SGTE that DO have taller final drives. The need for a 6th gear is purely asthetic...

[Bigmeanbulldog55]

The need for a 6th gear is purely asthetic...

Amen to that. Just buy a 6 speed shift knob tell all the chickies you've got a 6speed. Heck, why not considder reverse? Just say, "I've got a 6 geared transmission?" All the players will think you are the bomb yoe.