Need ST205 help ASAP! Options

[toytech]

Not really sure how to explain it, but we have some vacuum lines that are not plugged in and we have no idea of what to make of them. Please help! This is a JDM ST205 going into a 94celica that originally had a 5sfe. Here is the other info and pics. Please let me know what we are missing or how to install/hook up these lines.

we are using the stock harness from the 94. We are using ecu
89661-2b841. the car runs starts every time we just need to know where the
temp sensors are and where we are to hook up this main vaccum line. The
codes we are getting are 21 o2 sensor, 23 & 24 intake air temp sensor
signal. I attached a couple of pics of the vaccum line. It comes off the
bottom of the throttle body, goes to a hard line then slits to a smaller
vacumm line then wraps back up to the corner of the intercooler.

Please help us out, with either pics of your set up nice and close or tell me how to hook it up. Thanks.











This post has been edited by toytech: Dec 2, 2006 - 12:33 AM

[lagos]

where did you get the motor?
where did the harness come from?
where did the ecu come from?

your motor is NOT an st205. you have an st185 with a water to air IC.
the ecu your using seems to be an st205 one.
the harness came from your 5sfe or from a 94st205?

the hose your circled in red, is for the idle system. it gets connected to your intake that goes on the turbo.

the ecu you have (if its is a 205 one) is not for this motor. thats why your having issues. even if you get everything hooked up right, youll have to swap out to 550cc injectors because the motor you have only has 440s.

This post has been edited by lagos: Dec 2, 2006 - 3:41 AM