DIY - changing your transmission fluid/oil, M/T 7afe Options

[Batman722]

I changed the transmission fluid/oil in my 7afe recently and Manny (presure2) took some pics - thanks Manny
I was having some slight grinding going into 2nd gear in higher RPMs and I figured changing the tranny fluid would be a great idea. Since it has been changed, no more grinding

tools needed : ratchet, 24mm socket, 3-4qts transmission fluid/oil, oil drain pan, jack/stands
time : 30min - 1hr, depending on your mechanical skill level

DO NOT attempt this when engine is hot, wait until the engine is very cool/cold.


first you need to loosen this bolt (fill plug) with a ratchet and the 24mm socket

bolt removed


it is located here, it is facing the front of the car. The transmission is circled in yellow and the arrow is pointing to the bolt location

the bolts are usually very tight and could be difficult to loosen

next, jack up the front of the car (putting it on jack stands is always safer) and with the 24mm socket you need to loosen this bolt (drain plug)

Remove drain plug. The drain plug is located directly under the transmission. You may need to remove some of the plastic under the engine for easier access. Be sure to put the oil drain pan under the bolt when removing because the old fluid/oil will be pouring out.

now after the old oil has drained out (10 min later), replace the drain plug - make sure it is secure - and lower the car.

My personal choice
Pennzoil Synchromesh


pour 3-4qrts of the Synchromesh into the fill plug hole (you might want to use a long funnel or pour/squeeze from the bottle into the hole) until full - it will start pouring back out. I used just less than 3qrts



Once full, replace fill plug - make sure it is secure - and wipe up the excess that has spilt.

Done.

Notes :
- be sure to dispose of old fluid/oil properly
- according to the BGB - 7a transmission refill = 3.5qrts, 5s transmission refill = 2.6qrts
- this procedure should be the same/similar for both 7afe and 5sfe

[Batman722]

Randy, did you change the fluid on the Celica or the Corolla ?

[97lestyousay]

Randy, did you change the fluid on the Celica or the Corolla ?

Clearly since this is not an "allinclusive" forum it was
the celica.


OK you caught me, I am using this forum for info on
my other toys as well. I am changing it in the rolla. It is
a little tighter though. I'm just using some 75-90 because
I am replacing this tranny soon and I couldn't find sycromesh
anywhere around here . To bad GT4s don't have hubs
I need to rebuild one on my truck.