My fogs quit working, EDIT: all better guys!! Options

[95CelicaST]

Well I hooked up my ST202 fog lights last night finally. I had the wires from my old PIAA fogs still routed down there, so I cut the connectors off the fog lights and the PIAA lines and put on some connectors. I plugged them all in and turned the lights on and they were working fine. I drove all last night and they were still all working fine. I came to work and parked and I could see that they were on because of the reflection off the bumper in front of me, but when I came back out shortly after they were not working. I checked the connections and they look fine. I didn't wrap the connections in electrical tape yet, but the entire connection is incased in plastic and rubber, and it isn't wet.


hmmmm... any thoughts?

This post has been edited by 95CelicaST: Jan 26, 2007 - 7:19 PM

[95CelicaST]

the reason i said to chheck your fuses is that you ssaid you had not taped the wires so any bare wire could cause a fuse to pop but if the fuses are good that means powers is good so i would then check connections and then go to ground because if it is loose then you will have no contact source for your circuit.

ah. I see. Yeah I'll check here in an hour. I would have wrapped it up, but we didn't have any tape sitting around