Seat Harness mounting, following on from 'Race Seats!' thread.. Options

[raz128]

Anyone want to clear this up for me?
I've got a 4point harness on my driver seat and a 3point harness on my passenger seat
When I bought the 3-point harness. The instruction booklet said to mount the tail strap of the harness between 0-45 degrees paralell to the ground which i did on the passenger side.
After doing some research to see if i could confirm it, the Schroth harnesses said the same thing

However i did come across this:
http://www.gforce.com/pdf/harnessinstall.pdf
for those too lazy to read it (or cant run pdf files) it says it's best to mount the tail strap -5 to +30degrees from a horizontal line to shoulder height.

Which is best mount to use? The lower point under the original rear seats or on the C-pillar?
The mounting point on the C-pillar would be within -5 to +30degrees that the pdf file states. but does it satisfy the 0 to +45degree instructions by OMP and Scroth?





This post has been edited by raz128: Jan 30, 2007 - 10:18 AM

[Davesceli]

Not to add gas to the flames but...playr did you read ALL those instructions. That diagram is for racers using a HANS device. In the case of a HANS device max angle is 20 degrees. Just letting you know.




This post has been edited by Davesceli: Jan 30, 2007 - 10:09 PM