6G Celicas Forums

Welcome Guest ( Log In | Register )

> 96 5sfe won't rev past 3k-FIXED
post Feb 17, 2007 - 1:49 PM
+Quote Post
two55309

Enthusiast

Joined Feb 17, '07
Currently Offline

Reputation: 0 (0%)




OK a little bit a history first. 1996 celica with a 5sfe 2.2. brother in law threw a rod in the car gave it to me. Replaced the engine with a 3sfe block and used everything else from the 5sfe (i mean everything. all i used was the block and head from a 3sfe) got everything back together and car fired right up. ran perfect no problems. drove to the gas station. got some new gas in the tank. drove home (ran perfect all the way back) parked the car for the week because still needed to fix a steering leaking problem. Next weekend, started car went for a little ride around the neighorhood to let things warm up. Half way through the ride, car started acting up. Wouldn't rev past 3k. Would hit 3k and knock back down to 2k. Acts like engine dies and then comes back. Replaced the spark plugs, the coil, the dist cap and rotor. Also replaced the crank angle sensor (it had given me trouble before and so i went ahead and replaced it.) Still the same problem.

It's weird. The car is hard to start now, taking a couple of tries before finally starting, and then if you hit the gas before its warm it dies. Once the car is warm its fine. But once you try to rev, it hits 3k, dies, picks backup at 2k and idles okay. I know it dies at 3k because i can hook up a timing light and watch and at 3k the light quits flashing.

Anyone have any ideas at all? The only thing i can think of at this point is a possible fuel system problem.

thanks

This post has been edited by two55309: Feb 25, 2007 - 10:32 PM
 
Start new topic
Replies
post Feb 25, 2007 - 10:36 PM
+Quote Post
two55309

Enthusiast

Joined Feb 17, '07
Currently Offline

Reputation: 0 (0%)




FIXED.

turns out that i'm a moron. always remember to question yourself. turns out when i was reinstalling the engine i only hand tightened a bolt on the rear of the intake tube that is a ground for the eletrical system (for the injection and fuel system to be more precise). I had hand tightened and before i got a chance to put a wrench on it, i had gotten distracted. it was tight enough at first that it made good contact but through normal vibration it had backed off. every time i would rev, a hose along the firewall would hit it and cause it to break ground. found it by pure accident, just wiggling until the car.

man i feel stupid now

Posts in this topic


Reply to this topicStart new topic
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: November 24th, 2024 - 11:42 PM