6G Celicas Forums

Welcome Guest ( Log In | Register )

> Valve Stem Seals, White/Blue smoke when I start up
post Apr 4, 2007 - 2:43 PM
+Quote Post
Manny



Enthusiast
*
Joined Feb 8, '07
From Oakland, Ca USA
Currently Offline

Reputation: 0 (0%)




Hey Everyone....

I noticed some bluish white smoke coming from my exhaust in the morning after my car has been sitting overnight... This goes away within 30 seconds and doesnt happen again until i let it sit overnight again....

In my experience this has usually been a ring or valve stem seal issue.

How difficult is it to replace the seals myself on a 5SFE engine? Ive done similar work on older cars (pre 1980), but I am a newbie on working on anything like this.

I can get the seals for less than 40 bucks new, but I dont want to have to spend hundreds on labor.



Also, How important is it that I replace the seals right now? The car runs fine and I have no issues with engine temp or even burning oil, its just the smoke in the morning. I dont know enough about toyotas to say if it can wait or not... I had an older car that lasted years with a similar issue, and after I sold it.. the new owner ran it for another 2 years before the water pump went, so he replaced the seals and the water pump since he was already workin on it.


--------------------
-M-
 
Start new topic
Replies
post Apr 4, 2007 - 7:16 PM
+Quote Post
bindertch



Enthusiast
**
Joined Aug 18, '04
From Silverdale, WA
Currently Offline

Reputation: 0 (0%)




QUOTE(alltracman78 @ Apr 4, 2007 - 3:48 PM) [snapback]543222[/snapback]

You don't have to remove the head to replace the valve seals.
Guides yes.
Seals no.


Yes there is a tool that can hold the valves in place with air but you still have to remove the timing belt to remove the cams so you can remove the springs and change the seals.

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: February 22nd, 2025 - 9:31 PM