Few issues Options

[Defgeph]

From the begining of my swap I've had low vac issues. I replaced hoses tightened everything up capped off holes.

I eliminated my AC and power steering. I have the hose for the AC idle up capped. Would I be better off capping the two PS vac lines?(current setup) Or should I connect them to each other with a hose. I'm close to having full vac, but its still alittle off.

Second thing, when I slow down and put the car into neutral the RMP's dip way below normal idle. After running at like say 650-750 rpm for a few seconds, it raises back to 1000 where its been since the begining of this project. Sometimes the car stalls, I looking for some suggestions or ideas.

I've checked timing, its set at 10d's.


Thanks guys

[Defgeph]

Brian, I'm wrong. I think your on the money with -9.9 psi. From what I've seen in that converter it makes sense. I could swear I heard or read somewhere that it reads negative pressure in KPA

Jeremy, I can't wait to hook up with ya man. Another gauge sounds great dude