Interior MODS ??, new questions and ideas Options

[NaderG]

I want to do some work on the interior of my 96 convertible .... so its basicly taking the removable parts out , spray it and re-install it , now how relaible is spray paint , specially with major sun exposure ? will it chip and stuff ? .. also what kind of paint is best ? any special technique or good pointers ? .... is any part specially tricky to take out ? ...... my seats leather is badly damaged , i cant think of anything to do to them and i need some ideas ...so new seats , i dont know how much would leather cost ..any ideas ?

This post has been edited by NaderG: Jun 21, 2007 - 3:52 PM

[jason]

neo wedge bulbs will only work well for the fan speed selector and the inside/outside air button, if used, the a/c switch wont light, and the top 5 buttons will be dim, the defroster button has its own little bulb in there separatly as well. soldering isint too hard with practice, if you can solder well, it turns any wire job into a clean one cuz everything can be heat shrinked and look like its supposed to be there instead of a twist n tape type of job. if you want to do your cc unit yourself id look to get a bunch of led's and aim them at their respective areas to give maximum lighting besthongkong.com is a good site, bright bulbs cheap. youll have to calculate out resistance depending on how many leds you end up using. id use 3 for the temp select, one for the top 5 buttons, 2 for the fan speed OR a neo wedge bulb, one for the inside out selector, one for the a/c button and one for the defroster button. if you want to change the indicator lights theres another 9 that are needed. that will give you a VERY nice cc unit, but hey, go the extra mile and do it right the first time. pittfirefighter also will hook you up with a modded cc unit. all depends on if you want to diy or send it out for someone else to do it for you