 3rd gen swap wont start |
 Jun 8, 2007 - 11:09 PM
|
 
|
 Enthusiast  Joined Apr 4, '05 From ST PAUL, MN Currently Offline Reputation: 3 (100%)  |
starter wont crank...just clicks from the inside.(of car).there seems as if there is no power going to the starter..wierd thing is that the radiator fan stays spinning.rechecked all wiring harness plugs and ground..starter wont crank over..checked starter today and it is working fine. please can anyone help with this problem....wiring harness was made by dr.tweak so i trust that it is fine..ooh yeah i did and have checked all the fuses like 30 times already even have one of my buddys do it like 10 times..everything is right...
This post has been edited by RUNNIN-LOW: Jun 8, 2007 - 11:26 PM --------------------  |
 |
Replies
|
Jun 9, 2007 - 5:05 AM
|
|
 Enthusiast Joined Aug 17, '04 From California Currently Offline Reputation: 20 (100%) |
Make sure all your grounds are good and are connected to a good piece of metal, without paint. I had the same issue with my swap and i think it was lagos who said check the grounds. I ended up finding one wire i didnt bolt to the tranny... and sure enough the engine turned over right away after i connected the wire.
 Good Luck!
This post has been edited by eggman40: Jun 9, 2007 - 5:07 AM |
Posts in this topic
RUNNIN-LOW 3rd gen swap wont start Jun 8, 2007 - 11:09 PM
OOBE Check the crank position sensor. On my Supra, the ... Jun 8, 2007 - 11:30 PM toyotacrazy QUOTE(RUNNIN-LOW @ Jun 8, 2007 - 11... Jun 9, 2007 - 5:37 PM RUNNIN-LOW yes the enigine will turn over by hand..try that t... Jun 11, 2007 - 12:29 AM phattyduck Have you tried a different battery? The click is ... Jun 11, 2007 - 3:02 AM
toyotacrazy QUOTE(phattyduck @ Jun 11, 2007 - 3... Jun 11, 2007 - 5:23 AM
DSToyo QUOTE(phattyduck @ Jun 11, 2007 - 4... Jun 11, 2007 - 10:14 AM RUNNIN-LOW kk today i figure out or i think i did..good point... Jun 12, 2007 - 8:08 PM toyotacrazy QUOTE(RUNNIN-LOW @ Jun 12, 2007 - 8... Jun 12, 2007 - 11:03 PM scothaniel I had the single click when I had a bad ground (th... Jun 12, 2007 - 11:44 PM toyotacrazy QUOTE(scothaniel @ Jun 12, 2007 - 11... Jun 13, 2007 - 4:44 AM RUNNIN-LOW i didnt check that yet the circuit opening relay..... Jun 13, 2007 - 12:02 AM RUNNIN-LOW kk got pictures but havent loaded them up yet..but... Jun 17, 2007 - 10:40 PM scothaniel Do you have the injector resistor pack in? Do you ... Jun 18, 2007 - 12:40 AM toyotacrazy QUOTE(scothaniel @ Jun 18, 2007 - 12... Jun 18, 2007 - 6:24 PM RUNNIN-LOW These are the plugs that has no other plugs to plu... Jun 18, 2007 - 7:14 PM scothaniel Ok, it looks like you have some 3rd gen connectors... Jun 18, 2007 - 8:20 PM toyotacrazy QUOTE(scothaniel @ Jun 18, 2007 - 8... Jun 18, 2007 - 8:38 PM RUNNIN-LOW k well humm.. where do i get the (4th pic)injector... Jun 18, 2007 - 9:36 PM toyotacrazy QUOTE(RUNNIN-LOW @ Jun 18, 2007 - 9... Jun 19, 2007 - 6:08 AM phattyduck QUOTE(RUNNIN-LOW @ Jun 18, 2007 - 7... Jun 19, 2007 - 1:26 PM scothaniel Let me check my old harnesses tomorrow - I may the... Jun 18, 2007 - 9:56 PM scothaniel I'm not sure what that 3rd pic is. It looks li... Jun 19, 2007 - 4:39 PM RUNNIN-LOW well if anyone can could they take pictures of the... Jun 19, 2007 - 6:17 PM eggman40 Ill have a pic up tomorow Jun 21, 2007 - 2:56 AM WannabeGT4 pic 2 looks kinda like it may be for the pressure ... Jun 21, 2007 - 7:12 AM scothaniel Pic 6 is definitely a 2nd gen injector resistor pa... Jun 21, 2007 - 10:29 AM WannabeGT4 QUOTE(scothaniel @ Jun 21, 2007 - 10... Jun 21, 2007 - 11:08 AM scothaniel Sorry man, I miscounted. I was looking at pic 7 wh... Jun 21, 2007 - 2:15 PM phattyduck QUOTE(scothaniel @ Jun 21, 2007 - 12... Jun 22, 2007 - 12:48 PM WannabeGT4 6 may very well be for a noise supressor but I don... Jun 21, 2007 - 4:26 PM RUNNIN-LOW thanks everyone for helping me out dame what would... Jun 22, 2007 - 7:37 PM laff09 QUOTE(RUNNIN-LOW @ Jun 22, 2007 - 7... Jun 22, 2007 - 11:54 PM 95WhiteOnWhite Doesnt look like any supermodel I ever seen Jun 23, 2007 - 11:46 AM shubert_ae102 its the sylinoid , my corolla did the same thing ,... Jun 24, 2007 - 12:21 AM RUNNIN-LOW well thanks to all that are tryin to help..thanks ... Jun 25, 2007 - 6:58 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 28th, 2024 - 11:30 AM |