3vz-fe puzzle, Cannot get spark with 3vz-fe Options

[Happy420]

I am kinda new to this kind of thing so bear with me if I make a mistake in protocol.

I have a '92 Camry that came with a 3vz-fe motor. The car was bought used from a "dealer" with less than 133,000 2 yrs ago. 19.6 miles after leaving the lot the motor blew a rod. This was due to the sludge build-up problem I have read this engine has. Anyway, we have since replaced the engine with a used one from overseas with 44,000 miles on it. Now the problem I am having is that I cannot get the engine to fire!!!!!

I have tried replacing the igniter and coil as well as having an all new distributor, rotor, Plugs, etc. Still the best I can get is only 12v to the plugs.

Can anyone please point me in the right direction of how to proceed with troubleshooting this since I cant even get it to start? I have over $6000.00 USD into this car and would love to drive it more than the 19.6 miles I got off the lot.

Either new post's or PM's to the below e-mail would be greatly appreciated.
jpalko1102@yahoo.com

[6gcSTVT]

I would have went right back to the lot you drove it off of and caused a huge ruckus about a piece of **** they sold me and would have had them fix it for you for free on the spot. If they were to sell you a "used" car it should have gone over a certain inspection before they sell it to you. No car should 19 miles and throw a rod. Like Presure2 said, this site isn't specifically knowledged in ur engine. But good luck with everything and hopefully you get that engine started