![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Aug 5, '06 From Maryland Currently Offline Reputation: 2 (100%) ![]() |
I am trying to install my ST202 fog lights and I am stumped. In the car's fuse box inside the car, there is a fuse called "FOGS". Mine even has a 20amp fuse in it already. I can't seem to find where it leads outside the car. Where is the switch/output for the fogs?
|
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Aug 5, '06 From Maryland Currently Offline Reputation: 2 (100%) ![]() |
Thanks for the replies! That's how I'm thinking to do it netrata. I have the relay next to the fuse box and a switch on the dash. I just need to figure out how to route the wire from the dash to the relay. Where did you put the wire to go from the cabin to the engine bay? I'm thinking of drilling a hole about 4" under the steering shaft and just sticking it through... that is, unless there is a predrilled wire hole that has room for one more that I've missed.
|
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 14, '06 From Northampton, UK Currently Offline Reputation: 5 (100%) ![]() |
QUOTE(phokur @ Jul 2, 2007 - 2:54 AM) [snapback]574177[/snapback] I can't find the wire that comes out of the fuse box. I've been checking for continuity and can't seem to find where it leads. I've checked all pics on here and can't seem to find the relay or anything to tap into. I'll just tap into the fuse holder itself, run to an external fuse, then to the relay... Well I'm going to need to trace all the wires to create my own wiring diagram unless anyone has an appropriate Toyota wiring diagram. I'll be doing that this evening so I'll post my findings. QUOTE(phokur @ Jul 2, 2007 - 4:34 AM) [snapback]574193[/snapback] unless there is a predrilled wire hole that has room for one more that I've missed. From the relay box with the turn signal / indicator flasher unit, follow the wires that run out of the blue plugs. They run through a hole right in the top corner of the firewall into the fender and then through another grommet into the engine bay. If you unwrap the black electrical tape around the grommets you'll then be able to easily get several more wires through the grommets. Once it is all in place, use fresh electrical tape to bind the grommet back onto the wiring loom. You'll need to temporarily remove the plastic wheel well liner but that is an easy job - about 10 screws and bolts hold it in place. This post has been edited by BloodyStupidDavey: Jul 2, 2007 - 3:21 AM -------------------- Davey
Items for sale |
![]() ![]() |
Lo-Fi Version | Time is now: February 24th, 2025 - 12:15 PM |