st202 climte control in st204.., is that possible? Options

[lubu]

juat wondering what would i need in order to swap the auto climate control from an st202
to an st204...tired of its getting really hot and really cold and adjusting all the time.

found this..



is that all the stuff i need for the swap??

edit: has basically every thing excep the compressor..and the a/c unit

This post has been edited by lubu: Jul 22, 2007 - 11:16 AM

[soven]

ah sorry, thought you meant the other way round.

Good luck. I had a brief look behind the aircon units of both of the types and they looked pretty different. Will probably open them up again this weekend and see whats the difference if you have not found your answer by then.

[BloodyStupidDave...]

ah sorry, thought you meant the other way round.

Good luck. I had a brief look behind the aircon units of both of the types and they looked pretty different. Will probably open them up again this weekend and see whats the difference if you have not found your answer by then.

They are very different. To do the swap you'll need:

* an extra engine bay sensor
* JDM climate control compressor (pump) in the engine bay. It is different to the US/UK one.
* replace the temperature sensor inside the aircon heat exchanger (the middle box behind the glove box)
* a different aircon resistor pack
* an aircon power transistor (not fitted for aircon)
* a light sensor (goes into the top of the dashboard)
* a cabin temperature sensor (goes under the steering wheel)
* an air tube that goes between the cabin air sensor and near the drivers' foot rest
* two short aircon wiring looms
* cabin wiring loom from a donor car with climate control
* different aircon amplifier module
* an extra relay (climate control high speed relay)
* an air vent mode solenoid from donor car (they are different)
* a temperature mix solenoid from donor car (solenoid not fitted in aircon)
* temperature mix actuator cable from donor car (they are different)
* climate control (the unit with switches on that goes in the center console
* climate control ECU (not fitted in aircon, sits on top of the main ECU)

You'll need to completely unplug the cabin wiring loom then remove the arm rest, lower centre console, steering wheel, dashboard. You'll then need to combine your old loom with the donor loom; change over the aircon heat exchanger temperature sensor; run wires to the engine bay sensor; diagnostics connector and compressor; and install the remaining two cabin sensors. Install all the remaining bits, attach the cabin wiring loom to the dashboard again and put everything back together.

In short, the work involved is probably a little short of an engine swap. It isn't really worth the effort involved unless you like a challenge or really really want climate control.

This post has been edited by BloodyStupidDavey: Jun 2, 2008 - 4:28 PM