Swap 94 GT to 3sgte, (Car sold parts available) Options

[y2komar]

I am happy to say that I am finally starting my swap. I have a 94 GT 5sp.
I am putting a st185 jdm alltrak engine. I will be keeping my tranny to make the swap easier.

as I was reading the stickies on the swap i read that I should have gotten a clip. Well too late. I already bought the engine and most vital components. On the sticky post I read I need

engine
ecu
wiring harness
3rd ecu plug
afm
ignitor
coil
injector resistor pack
fuel pump resistor
fuel pump relay
turbo pressure sensor
air intake piping

well I don’t know if I have all parts so I took pictures of them and I hope you guys and girls help me labeling each one of them. I am hoping I have everything.




















This post has been edited by y2komar: Sep 19, 2010 - 4:24 PM

[y2komar]

I will soon start to order parts for the swap.
For those that have already done this; what do I need to start ordering.
I will also need the wiring done.
where should I start

This post has been edited by y2komar: Sep 21, 2007 - 11:42 AM

[y2komar]

I started by removing the 3s wiring hardness. Damn plugs



I then started to remove the 5f engine so that I can send out the wiring. I will be instaling the gt ac so I tied the compressor without completely removing it so that I can just reinstall it into the 3s


I went to a old school corolla swap meet and came by a used magnaflow muffler 3 inch inlet for 30 bucks.