My 5sfTe project, Photo's are big 56k warning... sorry Options

[1bwilson]

So since I really dont have a set 5sfte post just my "need a little help" post, I figured Id make one aswell.

What I have:

Built 5sfe:
CP pistons - In
3sgte rods - In
crank milled to fit the rods - In
PP'd head - In
Metal head gasket - In
ARP head studs - In

Turbo parts:
3s Manifold, Turbo, Oil lines, Coolent lines - In, In, In, In
DG custom IC piping - In
Ebay intercooler (cant remember the size) - In
Injectors 460cc - In
Walbro fuel pump - In
Greddy Type S bov - In
KO Racing DP - In
DG custom Mid pipe - In
SPark plugs gapped properly - In

Other stuff:
Oil filter - Done
Batt relocated to trunk - In
Devils own WI kit - In
Turbo xs manual boost controller - In
Emanage ultimate - here, waiting on the harness.
Boost gauge - In
EGT Gauge - In
AEM UEGO - In

Im rather suprized I havent had any major set backs yet (knock on wood!). Ive taken my time and set a daily goal up for myself and tried to stick with it. Even when I got ahead I cleaned up and planned the next day out. This way Ive been 80% ahead of myself on ordering small things like nuts and bolts that I missed or didnt have from used parts. Would be 100% but some how the tech's at my local toyota cant order the correct part even if I give them the part #'s.

This post has been edited by 1bwilson: Oct 3, 2008 - 10:37 PM

[1bwilson]

I should get all the gauges finished up tomorrow along with my final few couplings in the mail. Once thats all done all thats left is something to tune the fuel out a bit and tuning/dyno time. Anyone know how hot the first intake pipe comming out of the turbo can get? As you can see both my stock o2 and wideband o2 are VERY close (wideband actually rubs against it) the pipe. Im not sure if the pipe is going to get to hot for them and possible melt the wires. Once I have the couplings Ill know for sure actually how close they will be and possible re-adjust the piping again. Ill also snap a few shots of everything cleaned up along with the batt relocation and the badass RCR rear 3 point strut bar I got from Jeff