prototype sway bar links, custom sway bar end links Options

[97GTinKC]

http://us.f2.yahoofs.com/users/81f6d5b0_m4...h2w_ICBgXOT26H0

Got my prototype end links done, installed the right side only to see how/if I notice any difference or problems, I will bring them to the KC celica meet next Sat...



Bad news is I haven't found a reasonable supplier, still going to be around $150 /pair. (but that is better than the 1st supplier, they wanted approx $75 PER END = 600/car? )


Had them on a year, still tight,,, still too expensive,,,

This post has been edited by 97GTinKC: Mar 1, 2005 - 12:07 AM

[97GTinKC]

...and spedtoe169, if you know of a supplier, let me know.

by the time I put these in the lathe and shorten them, plus get decent mounting hardware, it will be around 120-150/pr.

and after dissecting my original, I find they are steel ball and socket and NOT the potted rubber (at least on my 97GT) so kind of a moot point,
At least the stainless will polish up nice!