 power antennas, question on them |
 Dec 1, 2007 - 4:44 AM
|
 
|
|
Enthusiast  Joined Sep 23, '07 From Netherlands Currently Offline Reputation: 2 (100%)  |
I'm planning on getting a power antenna, but I have a question.
Is it possible to only get it half way extracted instead of fully? I don't like it when my antenna is all the way out, it sticks out too far. |
 |
Replies
|
Dec 1, 2007 - 9:42 AM
|
|
 Enthusiast Joined Mar 15, '07 From Tennessee Currently Offline Reputation: 52 (100%) |
QUOTE(geetje @ Dec 1, 2007 - 4:44 AM) [snapback]618724[/snapback] I'm planning on getting a power antenna, but I have a question. Is it possible to only get it half way extracted instead of fully? I don't like it when my antenna is all the way out, it sticks out too far. the power antenna stops when it reaches a bump. Its the relay that detects when the motor is forced and stops it. so technically if you were to put some glue in the right spot, to prevent it from sticking out all the way it could. I would not recomend it tough, it is that leght for a purpose, then you will have bad reception. -------------------- Learned a lot in 10 years... I hardly log in anymore, last login Today Sept 6 2019, and I was forced just to clarify a post. LOL
If you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in 2grfe Swapped... Why I chose the 2GR, before you ask read here... A great civilization is not conquered from without until it has destroyed itself from within. @llamaraxing in Instagram is the best way to find me. I hardly log here anymore. |
Posts in this topic
geetje power antennas Dec 1, 2007 - 4:44 AM
geetje Thanks for your reply,
That's a good idea wit... Dec 1, 2007 - 10:51 AM beno Im not sure if that will work because the antena h... Dec 3, 2007 - 12:25 AM
geetje I've found a few sites where they sell an ante... Dec 7, 2007 - 1:13 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: February 22nd, 2025 - 10:48 AM |