Using a '93 3SGTE ECU on a '91 3SGTE Engine and Harness Options

[Dr_Tweak]

Some weeks back I had a customer doing a 3SGTE swap into a '91 Celica that I did a wiring conversion for. After he got it back and installed, I asked him for the part number on his ECU since I've seen many situations where the importers send the wrong ECU for the year of the harness. Sure enough, he had a '91 Harness but a '93 ECU. I advised him to get a '91 ECU, but he was having a hard time locating one.

About the same time, I started gathering parts and doing research for making jumper harnesses for various Toyota applications. I located the supplier for the female ECU plugs for a few different Toyota harnesses. When I got one in that matched the 3SGTE harnesses, I though, why not make a jumper harness that goes from a '91 harness to a '93 ECU, or a '93 harness to a '91 ECU? Then customers who run into this situation don't have to find another ECU or repin the whole harness.

Since I had this customer, Bryant, who had this very situation at hand, and since I happened to be going near where he lived on a recent road trip, I decided to whip up a prototype and give it a try.







There it is plugged into a 3SGE ECU as an example. This first one came out a little rough, the production model will be cleaner.

And here it is plugged into the car:



The jumper harness worked PERFECTLY. It fired up the first try and is running great, no codes and no problems at all

If anyone wants one of these jumper harnesses let me know, I'm currently building them to order.

Other applications for this setup include plug and play jumper harnesses for standalone units that don't already have a plug and play setup, like perhaps 3SGTE/Autronic, and so on.

-Doc

[lagos]

I thought about doing this in the past, but like jay said, it almost doesn't seem worth the cost.

You would need:

205 ecu (pricey and hard to find)
550cc injectors
igniter
map sensor
air intake temp sensor
intake manifold temp sensor w/ adapter
tvis rpm switch

You could also just repin your harness to make it work. It fairly simple to do, but the adapter harness would be nice in case you need to go back to the stock ecu.

Since the only real benefit to doing this would be to convert to a map based system, you could make it more simple by just buying a used vpc.

This post has been edited by lagos: Dec 29, 2007 - 6:02 AM