6G Celicas Forums

Welcome Guest ( Log In | Register )

> Lots of hesitation, What could it be?
post Jan 16, 2008 - 6:07 PM
+Quote Post
lipweb



Enthusiast
*
Joined Jul 7, '06
From usa
Currently Offline

Reputation: 0 (0%)




Well, I bought this car from my brother 2 days ago...he said he was just about to do a tune up and change the air filter...he didn't have the chance to do it and neither have I. Anyway, when I come to a stop my idle starts dropping from 900 to 800 to 700 and barely stays around 600 rpms...then when I pick up it pops and hesitates with some slight jerking and then it goes good again. What's that all about???
 
Start new topic
Replies
post Jan 17, 2008 - 5:27 PM
+Quote Post
lagos



Enthusiast
*****
Joined Aug 31, '02
From Philadelphia, PA
Currently Offline

Reputation: 8 (100%)




check what the CEL code is. That will tell you whats causing the problem.


--------------------
15PSI - 30MPG - Megasquirt Tuned
post Jan 17, 2008 - 7:01 PM
+Quote Post
lipweb



Enthusiast
*
Joined Jul 7, '06
From usa
Currently Offline

Reputation: 0 (0%)




QUOTE(lagos @ Jan 17, 2008 - 5:27 PM) [snapback]631679[/snapback]

check what the CEL code is. That will tell you whats causing the problem.



well I just finished the plugs, wires, cap and rotor...didn't hear any vac leaks at all and traced all hoses and couldn't find anything. since i started it up the check engine light turned off. the plugs were pretty bad and the rotor lead was burned too. I'll have to run it before I'll know for sure...
post Jan 18, 2008 - 10:39 AM
+Quote Post
laff09

Enthusiast
***
Joined Jul 28, '06
From Delaware
Currently Offline

Reputation: 0 (0%)




QUOTE(lipweb @ Jan 17, 2008 - 7:01 PM) [snapback]631723[/snapback]

QUOTE(lagos @ Jan 17, 2008 - 5:27 PM) [snapback]631679[/snapback]

check what the CEL code is. That will tell you whats causing the problem.



well I just finished the plugs, wires, cap and rotor...didn't hear any vac leaks at all and traced all hoses and couldn't find anything. since i started it up the check engine light turned off. the plugs were pretty bad and the rotor lead was burned too. I'll have to run it before I'll know for sure...

CEL maybe a bad o2 sensor

Posts in this topic


Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: December 1st, 2024 - 11:43 PM