supershannon77's new 5SFTE powered celica, NEW DYNO RESULTS PG5 285+WHP! PG6 vid added! Options

[presure2]

Hey all,
as some of you may know, shannon and jim (supershannon77) have a 3sgte swapped 6gc, that they bought from RJB on the forum.
They started off with a 91 auto GT, that they had a local shop install a "ebay special" turbo kit on. the shop installed the kit, and promptly blew the motor @ 5.5 psi.
shannon then had the shop source and install a 99 5s, and made ~147whp if I remember correctly, with the auto tranny, @ 5.5psi
They then blew said auto tranny. lol
So, IIRC, they sold the 5th gen to a friend, and bought RJBs car.
They have had a few problems with it, including a bad tranny, which Defgeph and I went down and replaced for them.
While i was down there, jims brother joe bought the old 5th gen back, with the blown tranny, and fresh 99 motor in it.
We disscussed diffrent options for it, including a manual tranny swap, but with the car having pre 93 electronics, and no knock sensor system, I convinced them the best thing to do would be to find a nice 6th gen chassis to swap the engine package into.
At that time, we also disscussed power goals, and to me, it seemed like Jim and Shannon were just looking for a streetable, everyday drivable car, with ~225 or so hp, to make the trip a bit more enjoyable .
Where Joe, on the other had, is really looking to build a BEAST down the road, 350+whp ect.
Fast forward a few weeks, and browsing the FS section here on the board, I see a nice 95 with a blown motor. http://www.6gc.net/forums/index.php?showtopic=49717&hl=
Bing, Bang, Boom, Jim and Joe are on it, and go put a deposit on the car.
We set everything up, and a few weeks later, Jim, Shannon, and Joe, load the 5th gen INTO the back of a uhaul truck, put the 6th gen on a car hauler attached to the back of said uhaul, and drove them up here.
here are some pics and discriptions of whats gone on since.

They arrive with the cars:


We get the 6th gen off the car carrier:


HOLY CRAP, they really DID stick the 5th gen in the back of the Uhaul!!!!!


this was NOT as easy as it looks:


mmmm yellow nology wires!! LMAO


With that done, the following morning we got right to work, and got the cars up and draining, and prepped to get the bad motor out:




Then we pulled the motor and tranny out of the 6th gen:

[presure2]

sorry to revive an old thread. just wondering if the turbo ever pooped out? also, were there any issues with hitting the radiator fan shroud? my turbo is pretty close to it already, I couldn't see how adding a 2 inch long adaptor would fit, unless the t3/t4 is smaller or shaped differently or something. one other thing, with the external wastegate being where it is, would it still be possible to leave the oil cooler in place, or is it necessary to relocate it?

the turbo is still going.
the turbo fits JUST barely. we had to trim the shroud to get the clamps and coupler on the outlet.
the oil cooler wont fit.

in regards to the oil filter relocation kit, was it only done due to the exhaust manifold/wastegate dump pipe ?

technicly, yes.