What to torque it to?, 6 hexhead inner cv bolts Options

[6gsillyca]

EDIT:

Can someone please tell me what the 6 hexhead bolts should be torqued to? My manual lists:

hub nut - 137 ft-lbs
driveaxle inner cv joint-to-differential side gear shaft flange - 27 ft-lbs
right driveaxle centre bearing bracket bolts - 47

None of these seem correct, but since my axles are *non-stock* I'm not sure what the technical part term would be for them.

END EDIT




I need to replace my outer cv boot. I was looking into getting a new axle shaft, because I have read it is easier to RnR the whole axle rather than individual parts (axle, cv joint, cv boot etc). Then you also shouldn't need to worry about any damage to your joint because of the craked boot.

I need to know what parts to order though. Cv boot is on the front pass wheel. Would the axle half come with both inners and outers, and then would I need to RnR the inner with the e153 inner from my current set-up?

Would someone be able to explain what the inner and outer axles are, and how/where the inner attaches to the outer?

Here is a link to my thread in another sextion, but I thought the boosted guys might know the e153/st185 axles a bit better.
http://www.6gc.net/forums/index.php?showtopic=57022

This post has been edited by 6gsillyca: Apr 15, 2008 - 12:42 AM

[6gsillyca]

So a st185 axle will come with both inners and outers assembled together from napa?

Do I just need to unbolt where the 6 cap head bolts are? Or is there another part after the inner cv joint that comes apart(before the 6 bolt piece)? I'm not 100% sure where the inner/outers connect, what stays and what gets replaced...

All I would need is a passengers side st185 rebuilt axle, and I should get everything I need? Or would I need the drivers side st185 axle?

Would I need any e153 components?

This post has been edited by 6gsillyca: Mar 24, 2008 - 7:23 PM