modding turn signals, how do i seperate the lens from back? Options

[axelrduvirage]

has anyone "BAKED" turn signal assemblies to separate the lens from the back? what temp? how long? any precautions? i just need to soften the glue and pop them apart right?

[stetsonaw]

Front 96-99 turn signals:
i asked for help on this a while back, and never got a response, so went it alone. preheat oven to 250, put ONE light on a cookie sheet and put it in the oven for 2 minutes, pull it out and try to pry apart. flat tip screwdriver helps. probably won't be soft enough yet, so keep trying after 60-90 second trips to the oven. have a philips screwdriver handy for the orange bit. once you get the bit out, just toss it in the trash, along with the screw. put the lens back on (after making sure no round rubber pieces from the screw hole are in the way [didn't do that, and i have it floating around the inside of the housing]), and flatten any areas that are pushed up due to prying. stick back in oven for about 45-60 seconds. pull out and again, flatten anything that needs flattened. now, repeat with the second one and enjoy!

JDM tails turn signal
items needed: exacto knife or razor blade, hot plate or stove top burner. (or heat knife)

turn light housing upside down, heat the blade up on the stove burner, cut all the way around the top of the blinker housing (the part facing up when it is upside down). the orange bit is huge in this thing, so make sure you get a big hole. you may heat the entire housing for about 60 seconds at 250 to loosen up the plastic and make it more pliable. once you get the top cut either off or pulled back (your choice), get a SHORT philips in there to take the screw out, and pull the bit out. superglue or caulk to put the piece back on, repeat with the other.

if you run into any problems, lmk.