ebay header, does anyone have it? Options

[blackbullet]

I was wondering if these ebay headers are good? does anyone have it? and what is the quality of it? any improvements?

http://cgi.ebay.com/ebaymotors/Toyota-Celi...sspagenameZWDVW

[_mikeE]

Nope, no CEL will be thrown or any engine lights and you will most definitely not pass emissions, also removing your stock headers, you're also removing your cat as well as it is built with the stock headers so if you don't do a custom exhaust with a new cat, you're an earth killer! lol
Also on the aftermarket headers, there are two holes, one with the bolts to bolt up the o2 sensor and one that should come with a bolt to cover the hole, but that 2nd hole is if you decide to do a wideband, if not, then just keep the bolt tight and covering the hole.

[crash60068]

Nope, no CEL will be thrown or any engine lights and you will most definitely not pass emissions, also removing your stock headers, you're also removing your cat as well as it is built with the stock headers so if you don't do a custom exhaust with a new cat, you're an earth killer! lol
Also on the aftermarket headers, there are two holes, one with the bolts to bolt up the o2 sensor and one that should come with a bolt to cover the hole, but that 2nd hole is if you decide to do a wideband, if not, then just keep the bolt tight and covering the hole.

well i mean as far as emissions here in illinois all they check is if my check eninge light is on or if any codes are stored since its an odb2. so i should be ok then.


but when anyone installed there headers did you have to jack up the car to remove the three bolts connected to the downpipe. also are these header a perfect fit or will i have to push down on the downpipe to connect the headers??? also did anyones bolts snap cuz my cars bolts are all rusted whats the best way to avoid this. i tried using WD-40 to take of the heat shield and the sheild cracked and i scard to go any furthur with this.