Jun 4, 2008 - 10:28 PM
|
|
|
Enthusiast ![]() ![]() Joined Jan 22, '06 From Savannah, GA Currently Offline Reputation: 1 (100%) |
So the car ran and drove fine for a couple days and then i was about to put it in my garage and it died. it didnt really sputter as if it was out of gas just suddenly stopped. i checked for spark and there is none. the coil has power but there is no power at any of the pins on the distributor which leads me to believe something in the wiring is bad or the ecu is fried somehow and power is not sent to the distributor to inturn send signal to the coil. i checked with a timing light to see if there was power through the wire from coil to distributor and there was none. so the coil is maybe bad but it might just not be getting the signal from the distributor. im extremely pissed about it all because i just got it running.
Also on another note did anyone else have a problem closing there hood after completing a swap. for some reason my hood is not able to close past the first latch. i think it is hitting my radiator but it is the stock radiator in the stock location so i dont understand why that would cause a problem. again any input is appreciated. thanks alot This post has been edited by 6G94celica: Jul 24, 2008 - 7:56 PM |
![]() |
Jun 8, 2008 - 8:12 AM
|
|
|
Enthusiast ![]() ![]() Joined Jan 22, '06 From Savannah, GA Currently Offline Reputation: 1 (100%) |
im not sure, i got ahold of tweak and im gonna try a new igniter and an MSD coil. im leaning towards the MSD blaster 2. any toehr ideas for the coil.
|
6G94celica No Spark and EVERYTHING has been checked Jun 4, 2008 - 10:28 PM
6G94celica Bump c'mon someones gotta have ideas Jun 5, 2008 - 7:14 PM
qatar11 QUOTE (6G94celica @ Jun 5, 2008 - 8... Jun 5, 2008 - 9:32 PM
stephen_lee who did your wiring? Jun 5, 2008 - 10:16 PM
6G94celica tweak did the wiring Jun 6, 2008 - 3:16 PM
stephen_lee i think distributor is just hal sensors. so you wo... Jun 6, 2008 - 6:24 PM
alltracman78 Have you made sure your timing belt didn't bre... Jun 9, 2008 - 10:16 AM
stephen_lee QUOTE (alltracman78 @ Jun 9, 2008 - 10... Jun 10, 2008 - 2:33 PM
6G94celica yes the rotor is turning so the timing belt is fin... Jun 11, 2008 - 6:29 PM
stephen_lee are you getting fuel?
if you are, the ecu could be... Jun 12, 2008 - 12:17 AM
6G94celica the wire on one of the ecu plugs or the fuel pump.... Jun 13, 2008 - 4:37 PM
trd-celica have you check the alternator,battery or starter Jun 13, 2008 - 7:05 PM
6G94celica QUOTE (trd-celica @ Jun 13, 2008 - ... Jun 14, 2008 - 2:39 AM
6G94celica so after a new igniter, coil, ecu checked and rech... Jul 24, 2008 - 7:56 PM
6G94celica come on someone has to have some ideas Jul 25, 2008 - 7:58 PM
lagos 1. Did you ever check for codes (regardless if you... Jul 25, 2008 - 10:58 PM
SlickRick sounds like its your ignition box, since u can not... Jul 25, 2008 - 11:42 PM
6G94celica QUOTE (lagos @ Jul 25, 2008 - 10:58 ... Jul 26, 2008 - 6:14 PM
lagos QUOTE i have ran codes and none show up, as far as... Jul 27, 2008 - 11:51 AM
6G94celica These are the readings i got on the 5 pins of 5 th... Jul 27, 2008 - 12:35 PM
lagos All those seem to be correct based on what I remem... Jul 27, 2008 - 1:24 PM
6G94celica ya my battery is a brand new optima red top but al... Jul 27, 2008 - 1:31 PM
lagos QUOTE (6G94celica @ Jul 27, 2008 - 2... Jul 27, 2008 - 1:41 PM
6G94celica well now all i need to know is whether or not i ha... Jul 27, 2008 - 1:56 PM
lagos Wait... who said your timing belt broke? How do yo... Jul 27, 2008 - 2:27 PM
6G94celica ok thats what i was looking for. i just pulled off... Jul 27, 2008 - 2:32 PM
6G94celica anyone know if the mr2 turbo timing belt will fit ... Jul 27, 2008 - 3:04 PM
lagos yes, since its the same motor.
but its total over... Jul 27, 2008 - 3:15 PM
6G94celica ok just checking im gonna get the new timing belt ... Jul 27, 2008 - 3:26 PM
6G94celica so the new timing belt is in and everything is bac... Aug 1, 2008 - 7:06 AM
xxFROZENxx Hey guys i think have a similar issue as 6g84celic... Aug 2, 2008 - 10:41 PM
6G94celica sounds like it. thats what my problem was but take... Aug 3, 2008 - 10:12 AM
xxFROZENxx yeah my timing belts fine..... so now i need check... Aug 4, 2008 - 1:08 AM![]() ![]() |
| Lo-Fi Version | Time is now: December 14th, 2025 - 2:29 PM |